There are two basic options:
Material supply only

Either work out your quantities and order by phone, or send us a sketch with dimensions so we can advise you on how much you are likely to need. Materials will normally be delivered within 2-3 working days.

Estimates:

We can offer estimates from dimensioned sketch plans. Photographs also help, but we cannot provide an estimate without a drawing. If a visit to your boat is required, we reserve the right to charge a call out fee, which is refundable from your first order. When we provide an estimate, it will have separate costs for Templating, Materials, Manufacture of panels, and Installation. We can, in addition, break the costs down into areas –for example, cockpit, bathing platform, decks. This will allow you to decide on the best way forward!

Full or partial installation

There are usually three stages in installation. The steps are:

1: Templating,
2: Fabrication of panels
3: Installation of panels.

Most areas can be laid in this manner. If your boat cannot be done like this, we will advise you the reasons for this, and possible ways around it.

1) Templating.

A template (usually of heavy paper –but sometimes MDF) is made of the areas to be decked. You can make your templates, or get us to make them for you.

2) Fabrication of panels

Most areas can be made in sections on a bench, which will reduce the dependency on weather, and the length of time the boat is out of commission. Panels are manufactured according to the templates.

3) Installation

Pre-fabricated panels are stuck down using a single part polyurethane based adhesive, in accordance with manufacturers recommendations, and any finishing completed. We can send the panels and adhesive, or install them for you.